How to Install a Segment 2x4 Pendant Light

Quick Answer

Installing a Segment 2x4 Pendant Light involves mounting the ceiling canopy, wiring the fixture, attaching the horizontal arm and glass globes, then adjusting the height and level. This guide walks you through each step with common pitfalls to avoid.

Step-by-Step Installation Guide

1. 1. Turn Off Power and Prepare the Junction Box: Switch off the circuit breaker for the room. Remove the old fixture and inspect the junction box. Ensure it is securely fastened and can support the pendant's weight. If needed, install a ceiling brace. Common mistake: skipping the voltage test. Always double-check with a non-contact voltage tester before touching wires.
2. 2. Assemble the Mounting Bracket: Attach the provided mounting bracket to the junction box using the screws included. Tighten firmly so the bracket is level. The bracket will hold the canopy and support the fixture's weight. If the bracket is not level, the entire pendant will hang crooked. Use a small level to check.
3. 3. Connect the Wiring: Using wire connectors, join the fixture's black wire to the house black (hot), white to white (neutral), and green or bare copper to the ground wire. Tuck the connections neatly into the junction box. Common mistake: reversing hot and neutral. This can cause the fixture to not work or create a shock hazard. Label wires if needed.
4. 4. Attach the Canopy and Vertical Rod: Slide the canopy over the mounting bracket and secure it with the screws. Then attach the vertical drop rod to the canopy's threaded nipple. Hand-tighten until snug. Over-tightening the canopy screws can strip the threads. Tighten just enough to hold.
5. 5. Mount the Horizontal Arm and Glass Globes: With a helper, lift the horizontal arm and attach it to the bottom of the vertical rod. Screw each blown glass globe into its socket on the arm. Do not overtighten the glass. Common mistake: glass globes can crack if forced. Finger-tighten only. Use gloves to avoid fingerprints.
6. 6. Adjust Height and Level: The Segment 2x4 Pendant allows height adjustment via the vertical rod. Loosen the set screw, slide the rod to the desired height (typically 30-36 inches above a table or counter), then tighten. Use a level on the horizontal arm to ensure it is straight. Check level from multiple angles. The two pairs of globes can make a slight tilt look obvious.
7. 7. Install Bulbs and Test: Insert the recommended bulbs (check fixture label for wattage and type). Turn the power back on at the breaker. Flip the switch to test. If the light does not turn on, turn power off and check wire connections. Common mistake: using bulbs with higher wattage than rated. This can overheat the fixture.

Product Details

• Segment 2x4 Pendant: The Segment 2x4 Pendant features a horizontal arm suspended by a sleek vertical drop rod with two pairs of blown glass globes. The two pairs of globes mean the fixture is heavier on one side, so leveling and secure mounting are critical to prevent sagging.